search

Lippert-components Electric Tongue Jack Bedienungsanleitung

Stöbern Sie online oder laden Sie Bedienungsanleitung nach Hardware Lippert-components Electric Tongue Jack herunter. Lippert Components Electric Tongue Jack User Manual [en] [de] [es] [it] Benutzerhandbuch

  • Herunterladen
  • Zu meinen Handbüchern hinzufügen
  • Drucken
  • Seite
    / 1
  • Inhaltsverzeichnis
  • LESEZEICHEN
    • Bewertet. / 5. Basierend auf Kundenbewertungen
Seitenansicht 0
(E) - EXT/RET SWITCH
- 226023
(G) - COURTESY LIGHT SWITCH
- 226018
(J) - LED LIGHT
- 226027
(K) - PLASTIC LENS
- 225885
ELECTRIC TONGUE JACK
OPERATING INSTRUCTIONS
IMPORTANT
Be sure to read and understand all instructions before installing, using or servicing this jack.
Be sure to read and understand all instructions provided by the trailer manufacturer that utilizes the jack. Lippert Components, Inc. is
not responsible for improper installation, use or maintenance of the Electric Tongue Jack.
WARNINGS!
Disregarding warnings may result in property damage, serious bodily injury or death.
NEVER allow anyone unfamiliar with this product to install, operate or service this product.
NEVER lift or level this the trailer without a properly installed footpad.
NEVER crank jack or couple trailer without preventing the trailer from rolling
NEVER exert excessive side forces to the jack unit.
NEVER allow anyone, including operator to put any body parts under the jack or the supported load during jack operation.
NEVER drop the trailer off the hitch ball.
NEVER exceed load capacity.
NEVER use jack to lift trailer for service or tire change.
NEVER move trailer before jack is fully retracted.
NEVER use jack unless footpad retaining pin is fully inserted through both sides of the jack’s inner tube.
MANUAL OPERATION
If 12VDC power is unavailable to operate the Electric Tongue Jack use the following directions to manually operate the jack:
TO EXTEND
1. Chock trailer tires
2. Be sure footpad (A) is pinned securely in place with clevis & hair pins (B).
3. Check ground surface under jack is firm and level.
4. Open rubber plug (C) on top of jack’s gearbox to expose manual drive shaft
5. Insert manual crank handle (D).
6. Turn handle clockwise until trailer is supported and coupler clears hitch ball.
7. Move tow vehicle away from trailer.
8. Lower trailer until it is level by turning crank handle counterclockwise.
9. Remove crank handle.
10. Replace rubber plug.
TO RETRACT
1. Follow Steps 1 - 5 in the extend instructions.
2. Turn crank handle counterclockwise until coupler properly mounts hitch ball.
3. Be sure inner tube of jack is fully retracted prior to moving vehicle.
4. Follow Steps 9 - 10 in the extend instructions.
ELECTRIC OPERATION
TO EXTEND
1. Follow Steps 1 - 3 in the Manual Operation extend instructions.
2. Push EXT side of switch (E) to EXTEND jack until coupler clears hitch ball.
3. Follow steps 7 - 8.
TO RETRACT
1. Follow Steps 1 - 3 in the Manual Operation extend instructions.
2. Push RET side of switch (E) to RETRACT jack until coupler properly mounts hitch ball.
3. Be sure inner tube of jack is fully retracted prior to moving vehicle.
ELECTRIC OPERATION CON’T
The Electric Tongue Jack is provided with a motor clutch. An OEM provided 30A fuse is located by following the RED OEM
provided power wire beneath the jack and will need to be replaced if it blows. It must be replaced with a 30A ATO-type fuse. Battery must be fully
charged, free of defect, and full of water prior to operating the jack. Low voltage from the battery will cause the fuse to blow prematurely.
The clutch will slip under two conditions: (1) the jack may have reached it’s extend or retract limit or that the tongue
weight of the trailer has exceeded the capacity limits of the jack. Items stored in the trailer can vastly influence the weight distribution
of the jack. Reorganize stored items if Electric Tongue Jack motor clutch continues to slip.
NOTE: The LCI Electric Tongue Jack has one wire coming from the motor. This wire must be connected to 12VDC.
WARNINGS!
♦ Release switch immediately when clutch noise occurs. The clutch is the overload protection for the motor. The clutch should not
slip during normal operation. This will cause excessive wear on the clutch and the motor.
♦ If left on for extended periods of time, the courtesy light (G) will drain the battery.
♦ The Electric Tongue jack is designed for jacking the trailer in a vertical disposition only.
(B) - CLEVIS PIN & HAIR PIN
(A) - FOOT PAD
LIPPERTCOMPONENTS, INC.
www.lci1.com Toll free: (866) 524-7821
(H) - SIDE RUBBER
PLUG
- 225876
FOOTPAD KIT
- 165253
(F) - PLASTIC TONGUE JACK COVER
- 225868
(C) - MANUAL OVERRIDE PLUG
- 225875
rev102611
(D) - MANUAL CRANK HANDLE
- 116112
Seitenansicht 0
1

Inhaltsverzeichnis

Seite 1 - LIPPERTCOMPONENTS, INC

(E) - EXT/RET SWITCH - 226023(G) - COURTESY LIGHT SWITCH - 226018(J) - LED LIGHT - 226027(K) - PLASTIC LENS - 225885ELECTRIC TONG

Kommentare zu diesen Handbüchern

Keine Kommentare
Verwandte Produkte und Handbücher für Hardware Lippert-components Electric Tongue Jack
Hardware Lippert-components Electric Rear Stabilizer Jack Bedienungsanleitung   (4 Seiten)
Hardware Lippert-components Schwintek Bunk Lift Bedienungsanleitung   (8 Seiten)
Hardware Lippert-components Schwintek Bunk Lift Bedienungsanleitung   (4 Seiten)
Hardware Lippert-components Electric Slideout System Bedienungsanleitung   (20 Seiten)
Hardware Lippert-components Hydraulic Through Frame Slideout Bedienungsanleitung   (36 Seiten)
Hardware Lippert-components 2 X 3 Slideout System Bedienungsanleitung   (15 Seiten)
Hardware Lippert-components 3 X 3 Slideout System Bedienungsanleitung   (15 Seiten)
Hardware Lippert-components Above Floor Slideout System Bedienungsanleitung   (12 Seiten)
Hardware Lippert-components Embedded Rack Slideout System Bedienungsanleitung   (16 Seiten)
Hardware Lippert-components Hydro-Sync Slideout System Bedienungsanleitung   (18 Seiten)
Hardware Lippert-components In Wall Slide-Out System Bedienungsanleitung   (15 Seiten)
Hardware Lippert-components In Wall Slide-Out System Winnebago Industries Bedienungsanleitung   (4 Seiten)
Hardware Lippert-components In Wall Slide-Out System Bedienungsanleitung   (16 Seiten)
Hardware Lippert-components Schwintek In Wall Slide-Out System Bedienungsanleitung   (11 Seiten)
Hardware Lippert-components Sofa Slideout System Bedienungsanleitung   (16 Seiten)
Hardware Lippert-components Coach Step Bedienungsanleitung   (4 Seiten)
Hardware Lippert-components Bike Rack & Tire Carrier Bedienungsanleitung   (11 Seiten)
Hardware Lippert-components Tent Camper Bike Rack Bedienungsanleitung   (8 Seiten)
Hardware Lippert-components Bike and Tire Rack Bedienungsanleitung   (15 Seiten)
Hardware Lippert-components Flow Down Aftermarket Bedienungsanleitung   (4 Seiten)
  • YBA DESIGN Welltech Trango Broadband Americ Corporation Emicon
  • Oregon Fahrräder BENDIX Traktor Lok8u Mobiltelefone Cannondale Fahrräder AOC CRT Monitore
  • Belkin F5U602ea Electrolux WE170PP Electrolux EHG6341FOK MSI MS-7021 Philips 278E9QJAB/00
  • Ryobi AG4031G Gebrauchs- und Pflegehandbuch Roland SH-32 Bedienungsanleitung Samsung SGH-B520 Bedienungsanleitung DoubleSight DS-23T Datenblatt